N Scale

Showing 17–22 of 22 results

  • Butte box cab train

    Boxcab Side Frame

    $19.95
    • This frame is for use with building the set of 2 or 4 Boxcab Motors as shown as an EF-1 or EF-5.
    • Two full size/length units on each end are required for 1 EF-1 set., or 4 full size/length units on each.
    • Frosted Ultra Detail, is required for production material
    • Do care should be taken not to break the springs off while mounting the side frames.
    • Use an EH-10 (Japanese donor engine) for the power.
    • Be careful not to take too much existing side frame off when fitting the new Milwaukee side frame.
    • Also note: there are ladders for the front and center side of the cab.
  • Double bridge trolley support

    Bridge Trolley Support (Set of 4)

    $27.95
    • creosote poles trolley support for viaduct.
  • Heat tender train

    Heat Tender

    $48.95
    • This model is shown in primer
    • This model is built with the body and under frame.
    • I recommend you supply a set of 3 axel, heavy duty, journal trucks for the project (not included).
    • The weight of a tender is 22.2g so about 12.9g needs to be added (not included).
    • Be sure to wash the model with water and a few drips of dish detergent and a tooth brush to remove any oil from processing before painting.
  • Pipestone Pass train tunnel #11

    Pipestone Pass Tunnel #11

    $98.95
  • Train signal base

    Signal Base (Set of 6)

    $18.95

    • Concrete signal base
    • Designed for Model Power 3 color signal
    • Be sure to wash the parts before attempting to paint.

  • Train Trestle Base up close

    Viaduct Base (Set of 4)

    $19.95

    • Concrete pier with a steel cap to connect to the steel pier legs.
    • Steel cap, designed from the Blacktail trestles, in Butte Montana.
    • Size .38” l x .30” w x .48” h (each)     Material Smooth Fine Detail Plastic